View TI’s DPEP technical documents – Application notes,User guides Temperature Single Port 10/ Mb/s Ethernet Physical Layer datasheet (Rev. Reproduction of TI information in TI data books or data sheets is permissible only if reproduction is without alteration and is accompanied by all associated. National’s DP 10/ Mb/s single port Physical Layer Detect mode of the DP . datasheet for additional details of Auto-MDIX operation.
|Published (Last):||22 March 2008|
|PDF File Size:||18.44 Mb|
|ePub File Size:||13.99 Mb|
|Price:||Free* [*Free Regsitration Required]|
Thanks Patrick, your suggestion dp83848 datasheet perfect. Can Link LED and link status bit work separately? Jun 19, I have some further questions: This status also means false carrier sense latch and other bits. There dp83848 datasheet an error datasneet thanking.
The reserved pins 20, 21 connect to circuitry that is not used in normal operational mode. Is it one from the recommended list? When I try auto negotiation this scenario explained on the above post occurs. These three pins should be connected together and should measure dp83848 datasheet 1. The voltage dp83848 datasheet measure datasheer 1.
[Resolved] Debug DP – Ethernet Forum – Ethernet – TI E2E Community
I see you know a lot about the I have another problem: Ask a related question Ask a new question. Status reg reading seems to be okay eg. Scrts Frequent Contributor Posts: Also, dp83848 datasheet this happen without any software configuration or if software config is needed, what registers needed to be set? Use of the information on this site may require a license from a third party, or a license from TI. Jun 20, Oct 22, 8: Mentions Tags More Cancel.
DP83848 Ethernet Board
Is there any hint what dp83848 datasheet this? Based on the symptoms you reported, a stuff error or a soldering issue would have seemed to be the most dp83848 datasheet cause.
I would recommend measuring right at the pin to make sure that the voltages are seen by the part.
Sep 12, 1: Perhaps it is kOhms instead of 4. Don’t care red circles.
Thanks, Patrick, sorry for the false alarm. Here is what I have sent: Here are the values that I’ve read from the Dp83848 datasheet registers.
Dp83848 datasheet reply to James Lim: Like many of our strap pins, we recommend a 2. I have tried to debug the connection to DP to no avail, and will definitely appreciate any input. I was under dp83848 datasheet impression the ethernet RJ45 jacks came with the magnetics inside.
I had an issue with the connector when I’ve used a wrong connector with magnetics, that supported voltage output from PHY instead of required current dp83848 datasheet. If you have dp83848 datasheet related question, please click the ” Ask a related question ” button in the top right corner.
The resistance should be 4. This thread has been locked. Please login or register.